Parameters
- Indicative consumption of the diluted product0.25 - 1.5 l per 1 m2 depending on substrate absorbency
- pH13 (strongly alkaline - caustic)
- Appearanceyellowish liquid - a concentrate that is diluted with water prior to application (the original colour of the substrate is preserved after drying)
Effective hydrophobic surface protection with Lukofobem 39
comparison table for easier selection from the range of hydrophobic preparations Lukofob
-
cost-effective solution – concentrate diluted with water
-
visible beading effect
-
water-based formulation without solvents and odor
-
high and long-lasting water-repellent effect
- limits penetration of water-soluble impurities
- reduces dirt accumulation and enhances self-cleaning ability of the substrate
- reduces surface efflorescence
- limits conditions for microbial growth
- protects against freeze damage and chemical de-icing agents
hydrophobic preparation is evenly applied over the entire surface, in multiple layers without intermediate drying, until the substrate is saturated (wet-on-wet), any excess product should be wiped off before drying
do not apply another layer after drying Lukofob 39, as it may cause whitish efflorescence
for hydrophobization of porous light, well-absorbent mineral substrates - lime-cement plasters and mortars, matured concrete surfaces, tiles, blocks, fiber cement, gas silicate, artificial stone based on cement, natural stone such as sandstone, limestone, cut brickwork, facing bricks and strips, fired or concrete roofing (whitish efflorescence may occur on darker substrates)
dilution of Lukofob 39 with water depends on the porosity and color of the substrate
1:10 to 1:20, usually 1:15 (spraying/coating)
1:20 to 1:40 (darker surfaces - spraying/coating)
1:50 to 1:100 (immersion)
Hazard warning
Danger
Causes severe skin burns and eye damage. Always follow the information on the product label.
